B1D16

B1D0D,B1D16-MIRROR VERTICAL POSITION SENSOR INPUT CIRCUIT HIGH - DOOR MODULE





For a complete wiring diagram consult Diagrams/Electrical.


- When Monitored:
Continuously.

- Set Condition:
When the Driver/Passenger Door Module senses a value above the parameter of the mirror sensor on the Mirror Vertical Position Signal circuit for over 60 ms., this code will set.

NOTE: This test covers both the Driver and Passenger code depending on the side the code appeared in.








Diagnostic Test


1. TEST FOR INTERMITTENT CONDITION
Turn the ignition on.
With the scan tool, record and erase DTC's
Operate the Mirror Switch in all directions several times.
Cycle the ignition from on to off three times.
Turn the ignition on.
With the scan tool, read DTC's.
Does the scan tool display B1D0D or B1D16-MIRROR VERTICAL POSITION SENSOR INPUT CIRCUIT HIGH?

Yes


- Go To 2


No


- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test.




2. TEST FOR A SHORTED MIRROR




Disconnect the appropriate mirror connector.
With the scan tool, erase DTC's.
Operate the Mirror Switch in all directions several times.
Cycle the ignition from on to off three times.
Turn the ignition on.
With the scan tool, read DTC's.

Does the scan tool display B1D0D or B1D16-MIRROR VERTICAL POSITION SENSOR INPUT CIRCUIT HIGH?

No


- Replace the Mirror.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test.


Yes


- Go to 3




3. TEST THE (P67) OR (P64) MIRROR VERTICAL POSITION SIGNAL WIRE FOR A SHORT TO VOLTAGE




Turn the ignition off.
Disconnect the appropriate Door Module C4 connector.
Measure the voltage between the (P67) or (P64) Mirror Vertical Position Signal circuit and ground.
Is there any voltage present?

Yes


- Repair the (P67) or (P64) Mirror Vertical Position Signal circuit for a short to voltage.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test.


No


- Go to 4




4. TEST THE (P69) OR (P66) MIRROR SENSOR GROUND WIRE FOR AN OPEN




Measure the resistance of the (P69) or (P66) Mirror Sensor Ground circuit between the Module connector and the Mirror connector.
Is the resistance below 2.0 ohms?

No


- Repair the (P69) or (P66) Mirror Sensor Ground circuit for an open.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test.


Yes


- Go to 5




5. TEST THE (P67) OR (P64) MIRROR VERTICAL POSITION SIGNAL WIRE FOR AN OPEN




Measure the resistance of the (P67) or (P64) Mirror Vertical Position Signal circuit between the Module connector and the Mirror connector.
Is the resistance below 2.0 ohms?

No


- Repair the (P67) or (P64) Mirror Vertical Position Signal circuit for an open.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test.


Yes


- Replace the appropriate Door Module.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test.