Symptom Related Diagnostic Procedures

*FRONT WINDOW MOVES ABOUT 3 INCHES AND QUITS





NOTE: The Driver circuits are shown but the Passenger side is similar.

For a complete wiring diagram Consult Diagrams/Electrical.








Diagnostic Test


1. TEST FOR DIAGNOSTIC TROUBLE CODES
Turn the ignition on.
With the scan tool, read DTC's.
Does the scan tool display any Power Window related DTC's?

No


- Go To 2


Yes


- Diagnose and repair the DTC(s).
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test.




2. WINDOW HALL SENSOR A AND SENSOR B SIGNAL CIRCUIT OPEN
NOTE: Both Window Hall Sensor Signal circuits (A and B) must be open or closed for the result of this test to be valid.

Disconnect the appropriate Door Module C2 connector.
Disconnect the appropriate Window Motor connector.
Measure the resistance of the Window Hall Sensor A Signal circuit between the Motor connector and the Module C2 connector.
Measure the resistance of the Window Hall Sensor B Signal circuit between the Motor connector and the Module C2 connector.
Is the resistance below 2.0 ohms on both Signal circuits?

No


- Repair the Window Hall Sensor Signal circuits for opens.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test.


Yes


- Replace the Window Motor.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test.