B2206

B2206-CURRENT VIN MISSING/MISMATCH

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
During power-up, the ORC/OCM monitors the CAN bus for the VIN message.

- Set Condition:
This DTC will set if the VIN information received from the PCM is different from the stored VIN.





Diagnostic Test

1. CHECK FOR ACTIVE DTC
NOTE: Troubleshoot any Ignition, Battery, Seat Weight Sensor, or OCM Internal DTCs BEFORE proceeding.

NOTE: Ensure that the battery is fully charged.

With the scan tool, read DTCs.
Select the module and DTC type.

OCM-Active

- Go To 2

OCM-Stored

- Erase code with scan tool, test complete.

ORC-Active

- Go To 3

ORC-Stored

- Erase code with scan tool, test complete.

2. CHECK THE VIN STORED IN THE PCM
With the scan tool, compare the VIN that is stored in the PCM to the VIN of the vehicle's VIN plate.
Does the VIN that is stored in the PCM match the vehicle's VIN?

Yes

- Go To 3

No

- Replace and Configure the Powertrain Control Module.
- Perform (NGC) POWERTRAIN VERIFICATION TEST VER - 5.Powertrain Verification Test

3. CHECK THE VIN STORED IN THE PCM
With the scan tool, compare the VIN that is stored in the PCM to the VIN of the vehicle's VIN plate.
Does the VIN that is stored in the PCM match the vehicle's VIN?

Yes

- Go To 4

No

- Replace and Configure the Powertrain Control Module.
- Perform (NGC) POWERTRAIN VERIFICATION TEST VER - 5.Powertrain Verification Test


4. REPLACE THE OCCUPANT RESTRAINT CONTROLLER
WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

WARNING: If the airbag control module is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and personal injury or death.

View repair.

Repair

- Replace the Occupant Restraint Controller.
- Perform the *AIRBAG SYSTEM VERIFICATION TEST - VER 1.Airbag System Verification Test