Installation

INSTALLATION





1. Position the shoulder belt through the upper slot in the trim.
2. Install the trim panel and install the bolts.
3. Position the door sill scuff plates and seat the clips fully. Door Sill Scuff Plate




4. Position the upper trim panel tab (1) into the B-pillar and seat the lower side of the trim fully.
5. Install the shoulder belt anchor bolt (3) and tighten to 39 Nm (29 ft. lbs.).




6. Engage the tab (2) on the lower edge of the trim cover (3) in the slot below the screw in the turning loop (1). Then press the upper edge of the trim cover over the top of the turning loop until it snaps into place.




7. Install the grab handle bolts (2) and tighten to 6 Nm (55 in. lbs.).