Second Row - Center

SECOND ROW - CENTER

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler Mopar(R) Parts Catalog.





1. Fold and tumble the left outboard second row seat for easiest access to the center seat back left hinge bracket cover (1).
2. Remove the three screws (2) that secure the cover to the center seat back left hinge bracket (3) and remove the cover.




3. Remove the screw (2) that secures the second row center seat belt lower anchor (1) to the hinge bracket (3) and remove the anchor.




4. Remove the two screws (3) that secure the belt web guide bezel (2) to the top of the center seat back panel and remove the bezel from the seat back and the belt.
5. Remove the trim cover (1) from the center seat back. Seat Back Cushion / Cover - Removal.




6. Remove the three screws (3) that secure the retractor (2) to the seat back frame (1).
7. Lift the retractor upward far enough to disengage the two tabs (4) on the retractor bracket from the keyed slots in the seat back frame.
8. Remove the second row seat belt and retractor from between the seat back foam and frame as a unit.