Rear

REAR

NOTE: The rear washer nozzle latch feature is a one time component, and will be damaged if the nozzle is removed from its mounting hole for service. If removed from its mounting hole for any reason, the rear washer nozzle must be replaced with a new unit.





1. Position the new rear washer nozzle (2) to the mounting hole in the liftgate outer panel (3). Be certain that the rubber gasket is in position on the back of the nozzle.
2. Reconnect the washer hose (1) to the barbed nipple on the back of the nozzle.
3. Push the hose and nozzle nipple into the mounting hole in the liftgate outer panel and engage the tab located above the nipple with the upper edge of the hole.
4. Using hand pressure, push firmly and evenly on the lower edge of the nozzle until it snaps into place.