Removal

REMOVAL





NOTE: The crossover and selector cables are manufactured as a cable "assembly" and cannot be serviced individually.

1. Pull up on gearshift knob (1) with moderate force to remove from gearshift mechanism.




2. Remove shifter boot/bezel (1) assembly from console by lifting up at mounting ring area.




3. Remove the center console assembly (1).




4. Remove three grommet plate-to-floor pan attaching nuts (1).
5. Remove crossover cable retaining clip (4) and disconnect from shift lever.




6. Remove selector cable retaining clip (2) and disconnect from shift lever.




7. Remove air cleaner assy (1).




8. Disconnect battery cables.
9. Remove battery hold-down clamp and battery (1).




10. Remove battery tray (1).




11. Disconnect cables (1) from the shift levers at the transaxle.

CAUTION: Pry up with equal force on both sides of shifter cable isolator bushings to avoid damaging cable isolator bushings.

12. Remove cable retaining clips (2) and remove cables (1) from bracket (3).




13. Raise vehicle on hoist.
14. Remove converter heat shield (1).




15. Remove remaining grommet plate-to-floor pan screw.
16. Remove cable assembly (1) from vehicle.