Door Window Stays In Drop Down Position

*DOOR WINDOW STAYS IN DROP DOWN POSITION





NOTE: Left side graphic is shown - right side similar.

For a complete wiring diagram Consult Diagrams/Electrical





Diagnostic Test

1. DTC PRESENT
With the scan tool, read DTCs.
Are there any window or door lock related DTC's

Yes

- Refer to symptom list for problems related to POWER WINDOWS or POWER DOOR LOCKS.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Go To 2

2. WINDOW DROP SWITCH SHORTED




NOTE: Ensure the window stops and the window alignment is properly adjusted before proceeding.

Disconnect the Door Latch C2 connector (on the latch assembly).
Close the appropriate door.
Raise the window to the fully closed position.
Does the window glass now travel to the full closed position

Yes

- Replace the Door Latch Assembly.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Go To 3

3. (Q58/Q59) WINDOW DROP SWITCH SENSE CIRCUIT SHORT TO GROUND




Turn the ignition off.
Disconnect the Window Regulator Module connector.
Measure the resistance between ground and the (Q58/Q59) Window Drop Switch Sense circuit.
Is the resistance below 1,000.0 ohms?

Yes

- Repair the (Q58/9) Window Drop Switch Sense circuit for a short to ground.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Replace the Window Regulator Module.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test