Rear

INSTALLATION





Before installation activate wiper system to ensure the wiper module is in the PARK position. Position wiper arm so that the tip of the blade is on the park line on the glass.

NOTE: When servicing the rear wiper motor, replace all three rubber well-nuts.

1. Install three bolts to the rear wiper motor. Torque screws to 6.5 Nm (60 in. lbs.).
2. Connect harness connector.
3. Install liftgate trim panel Liftgate Trim Panel - Installation.




4. Install the arm on the pivot.
5. Install wiper arm retaining nut and torque to 18-20 Nm (160-175 in. lbs.).
6. Install the rear wiper arm nut cap.
7. Connect the battery negative cable.
8. Close hood.