Step 1 - 10

ASSEMBLY





CAUTION: The cooler bypass valve must be replaced if transaxle failure has occurred. Do not attempt to reuse or clean old valve.

NOTE: If transaxle is being overhauled (clutch and/or seal replacement), the TCM/PCM Quick Learn procedure must be performed Testing and Inspection.

1. Install both output bearing cups (1) using Installer 5050 (3).




2. Install low/reverse piston retainer gasket (2). Make sure gasket holes line up with case (1).




3. Install low/reverse piston retainer (1).




4. Install low/reverse piston retainer-to-case screws (3)and torque to 5 Nm (45 in. lbs.).




NOTE: The Low/Reverse Clutch Piston has bonded seals which are not individually serviceable. Seal replacement requires replacement of the piston assembly.

5. Install low/reverse clutch piston (1).




6. Use figure Anti-ratching spring (1), guide bracket (2), Split sleeve (3), spacer (4), pawl (5) and stepped spacer (6) as a reference while assembling park guide bracket assembly.




7. Assemble park guide bracket assembly.




8. Install guide bracket (2) into position and insert pivot shaft (3).




9. Install anchor shaft (1) and plug (3). Make sure guide bracket and split sleeve are in contact with the rear of the transaxle case.




10. Install low/reverse piston return spring (1).