B2113

B2113-5-VOLT SUPPLY CIRCUIT HIGH





For a complete wiring diagram, refer to the Wiring Information Electrical Diagrams.

- When Monitored:
With the ignition on.

- Set Condition:
The Front Control Module (FCM) detects the (T103) 5 volt supply circuit voltage above 5.0 volts.





1. CHECK FOR ACTIVE DTC
1. With the scan tool, read the active DTCs.
2. Cycle the ignition switch from off to on, leaving the ignition on for a minimum of 90 seconds.
3. With the scan tool, read the active DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 2

No

- If the DTC is stored, check for an intermittent condition. Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. A/C PRESSURE TRANSDUCER
1. Turn the ignition off.
2. Disconnect the A/C Pressure Transducer harness connector.
3. Cycle the ignition switch from off to on, leaving the ignition on for a minimum of 90 seconds.
4. With the scan tool, read the active DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 3

No

- Replace the A/C Pressure Transducer.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

3. SHIFT MOTOR/MODE SENSOR ASSEMBLY
1. Turn the ignition off.
2. Disconnect the Shift Motor/Mode Sensor Assembly harness connector.
3. Cycle the ignition switch from off to on, leaving the ignition on for a minimum of 90 seconds.
4. With the scan tool, read the active DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 4

No

- Replace the Shift Motor/Mode Sensor Assembly.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

4. (T103) 5-VOLT SUPPLY CIRCUIT SHORTED TO VOLTAGE




1. Turn the ignition off.
2. Disconnect the FCM C1 harness connector.
3. Turn the ignition on.
4. Measure the voltage of the (T103) 5-volt Supply circuit.

Is the voltage above 5.5 volts?

Yes

- Repair the (T103) 5-volt Supply circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST. Body Verification Test

No

- Inspect the wiring and connectors for damage or shorted circuits. If ok, replace and program the Front Control Module (FCM).
- Perform the BODY VERIFICATION TEST. Body Verification Test