Door Module, Rear Left (DMRL)

B210E-BATTERY VOLTAGE HIGH



- When Monitored:
At all times.

- Set Condition:
The module senses voltage input above 16.5 volts for over 15 seconds.





1. CHECK ENGINE DTCs
1. Start the engine and run for two minutes.
2. With the scan tool, read the active ENGINE DTCs.

Are there any active ENGINE Charging or Battery DTCs present?

No

- Go To 2

Yes

- Testing and Inspection Perform the appropriate diagnostic procedure.

2. TEST FOR INTERMITTENT CONDITION
1. With the scan tool, erase all DTCs.
2. Make sure the engine is still running.
3. With the scan tool, read the active door module DTCs.

Does the scan tool display active: B210E-BATTERY VOLTAGE HIGH?

Yes

- Replace the Door Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test.