High Intensity Discharge Translator (HIDT)

B210E-BATTERY VOLTAGE HIGH



- When Monitored:
At all times.

- Set Condition:
The module senses voltage input above 15.9 volts for over 1five seconds.





1. CHECK POWERTRAIN CONTROL MODULE (PCM) or ENGINE CONTROL MODULE (ECM) DTCs
1. With the scan tool, read PCM or ECM DTCs.

Are there any Charging or Battery DTCs present?

No

- Go To 2

Yes

- Testing and Inspection for gas engine applications and perform the appropriate diagnostic procedure.

2. TEST FOR INTERMITTENT CONDITION
1. With the scan tool, erase all DTCs.
2. Start the engine and run for two minutes.
3. With the scan tool, read the DTCs.

Does the scan tool display active: B210E-BATTERY VOLTAGE HIGH?

Yes

- Replace the Headlamp Leveling Module (HIDT).
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
- Perform the BODY VERIFICATION TEST. Body Verification Test.