Cylinder Head Assembly: Specifications

CYLINDER HEAD

Right Side




Left Side





Tighten the cylinder head bolts
Step 1: All 30 Nm (22 ft. lbs.)
Step 2: All 45 Nm (33 ft. lbs.)
Step 3: All + 75° Turn. Do not use a torque wrench for this step.
Step 4: All + 50° Turn. Do not use a torque wrench for this step.
Step 5: Loosen all fasteners in reverse of sequence shown
Step 6: All 30 Nm (22 ft. lbs.)
Step 7: All 45 Nm (33 ft. lbs.)
Step 8: All + 70° Turn. Do not use a torque wrench for this step.
Step 9: All + 70° Turn. Do not use a torque wrench for this step.


HEAD BOLT RE-USABILITY





The bolts must be examined BEFORE reuse. If the threads are necked down the bolts must be replaced.






SURFACE VARIATION - WARPAGE

Flatness (Head Gasket Surface) 0.09 mm (0.0035 in.)






CAMSHAFT BEARING CAP

Left Side




Right Side





Install the Camshaft bearing caps
Hand tighten the retaining bolts 2 Nm (18 in. lbs.)

Tighten the bearing cap retaining bolts 9.5 Nm (84 in. lbs.)

INTAKE MANIFOLD

Intake Manifold Specifications

CAMSHAFT GEAR/SPROCKET

Camshaft Gear/Sprocket Specifications