Operation CHARM: Car repair manuals for everyone.
Home >> Chrysler >> 2013 >> 200 L4-2.4L >> Repair and Diagnosis >> Brakes and Traction Control >> Antilock Brakes / Traction Control Systems >> Wheel Speed Sensor >> Service and Repair >> Wheel Speed Sensor - Installation >> Front
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Front







INSTALLATION

CAUTION:
Failure to install speed sensor cables properly may result in contact with moving parts or an over extension of cables causing an open circuit. Be sure that cables are installed, routed, and clipped properly.





1. Install the wheel speed sensor head (3) into the knuckle (4). Install the mounting screw (2) and tighten it to 12 Nm (106 in. lbs.).

2. Install the routing clip (1) securing the wheel speed sensor cable to the knuckle (4).





3. Position the wheel speed sensor routing bracket (2) on the brake flex hose bracket (5) and install the mounting screw (1). Tighten the mounting screw to 18 Nm (13 ft. lbs.).





4. Position the wheel speed sensor cable routing clamp (4) on the outside frame rail (6) and install the mounting screw (3). Tighten the mounting screw to 18 Nm (13 ft. lbs.).

5. Install the speed sensor cable routing clip (2) on the outside frame rail (6).

6. Insert the wheel speed sensor cable through the hole in the body (7) and install the grommet (1) in the hole.





7. Lower the vehicle.

8. Connect the wheel speed sensor cable connector (2) to the wiring harness connector (3) on top of the frame rail (1).

9. Perform the Diagnostic Verification Test and clear any faults. ABS Verification Test

pro multis · About Operation CHARM