Pressure Control Solenoid - Installation

INSTALLATION






1. Install the pressure control solenoid (2) on to the valve body.

2. Install the bolt (1) to the pressure control solenoid (2) and tighten to 6 Nm (40 in. lbs.).





3. Install the valve body oil pan, use a bead of MOPAR(R) ATF RTV (MS-GF41).

4. Install the upper valve body oil pan bolts and tighten to 6 Nm (50 in. lbs.).

5. Lower the vehicle.





6. Install the solenoid pack connector (2) at valve body oil pan (1).

7. Raise and support the vehicle.





8. Install the lower valve body oil pan bolts and tighten to 6 Nm (50 in. lbs.).





9. Install the wire harness bracket (2) onto the trans and tighten to 6 Nm (50 in. lbs.).

10. Clip the wire harness (1) onto the bracket (2).





11. Install the Front Sound Damper Cover (2) and fasteners (1).

12. Lower the vehicle.

13. Install the air cleaner body

14. Install the engine cover.

15. Connect the battery negative cable.

16. Fill transmission and road test Fluid/Filter Service.