C006A-54

C006A-54-MULTI-AXIS ACCELERATION SENSOR - MISSING CALIBRATION

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Ignition on.

- Set Condition:
When the Anti-lock Braking System (ABS) Module detects that a new Dynamic Sensor has been placed on the vehicle, but it has not been calibrated.





Diagnostic Test

1. PERFORM ECU INITIALIZATION
1. Turn the ignition on.
2. With the scan tool, read and record the ABS DTCs.

WARNING:
To avoid possible serious or fatal injury, check brake capability is available before road testing.

3. Perform the ECU initialization with drive test and perform and the ABS VERIFICATION TEST. ABS Verification Test.

NOTE: The ECU Initialization process must include driving the vehicle into a 90° turn.

4. Park the vehicle.

Was the ECU initialization successful?

Yes

- Go To 2

No

- Perform the ECU Initialization routine again, if still unsuccessful.
- Go To 3

2. VERIFY THE DTC IS STILL ACTIVE
1. Turn the ignition on.
2. With the scan tool, erase the DTCs.

WARNING:
To avoid possible serious or fatal injury, check brake capability is available before road testing.

3. Test drive the vehicle by turning the vehicle left and right in a curving manner at a velocity between 15 and 35 km/h (9 and 22 mph).
4. Park the vehicle.
5. With the scan tool, read ABS DTCs.

Des the DTC remain active?

Yes

- Go To 3

No

- Test complete.

3. ANTI-LOCK BRAKE SYSTEM (ABS) MODULE
1. Turn the ignition off to the lock position.
2. Replace the Dynamic Sensor. Dynamics Sensor - Removal.
3. Perform the ABS VERIFICATION TEST. ABS Verification Test.
4. Test drive the vehicle by turning the vehicle left and right in a curving manner at a velocity between 15 and 35 km/h (9 and 22 mph).
5. With the scan tool, read the DTCs.

Does the DTC remain active?

Yes

- Replace the Anti-Lock Brake System (ABS) Module. Anti-Lock Brake System Module - Removal.
- Perform the ABS VERIFICATION TEST. ABS Verification Test.

No

- Test complete.