U0101-00

U0101-00-LOST COMMUNICATION WITH TCM

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
- With the ignition on.
- Battery voltage between 10 and 16 volts.
- Ignition Off Draw (IOD) fuse installed.
- Totally Integrated Power Module (TIPM) is configured correctly.

- Set Condition:
Bus messages not received from the Transmission Control Module (TCM) for approximately 500ms.





Diagnostic Test
VERIFY THE DTC IS ACTIVE

NOTE: Make sure the IOD fuse is installed and the battery is fully charged before proceeding.

1. Turn the ignition on.
2. With the scan tool, read active DTCs.

Is this DTC active at this time?

Yes

- Totally Integrated Power Module (TIPM) and perform the U0101-Lost Communication with TCM diagnostic procedure.

No

- Manufacturer Code Charts and perform the Stored Lost Communication DTCs diagnostic procedure.