Blower Motor Resistor - Installation

INSTALLATION






1. Position the rear blower motor resistor (3) into the rear heater-A/C housing (1).

2. Install the two screws (4) that secure the rear blower motor resistor to the rear heater-A/C housing. Tighten the screws to 1.2 Nm (10 in. lbs.).

3. Connect the wire harness connector (2) to the rear blower motor resistor.

4. Position the rear heater-A/C housing (4) to the rear inner quarter panel.





5. Install the two bolts (5) that secure the rear heater-A/C housing to the two brackets (3) located on the rear inner quarter panel (1). Tighten the bolts to 3 Nm (27 in. lbs.).

6. Install the bolt (7) that secures the rear heater core tubes to the rear inner quarter panel. Tighten the bolt to 3 Nm (27 in. lbs.).

7. Install the rear ceiling distribution duct Air Outlet - Installation.

8. Install the rear floor distribution duct Floor Distribution Duct - Installation.

9. Connect the negative battery cable.