Flexplate/Torque Converter Vibration Test Procedure

FLEXPLATE/TORQUE CONVERTER VIBRATION TEST PROCEDURE
- Start engine.
- With engine at idle speed and transaxle in P (Park) or N (Neutral), observe vibration.
- Key off.

Remove or Disconnect
1. Flexplate shield attaching bolts.
2. Flexplate to torque converter attaching bolts.
3. Rotate torque converter 120 degrees (1/3 turn).

Install or Connect
1. Flexplate to torque converter attaching bolts.
Tighten
- Bolts to 62 Nm (46 ft. lbs.)
2. Flexplate shield attaching bolts.
- Start engine and check for vibration. Repeat procedure until best possible balance is obtained.