MAP Lamp Removal and Installation

Removal Procedure
1. Disconnect the negative battery cable.
2. Pry off the map lamp lens.
3. Remove the screws and the map lamp.
4. Disconnect the electrical connector.




Installation Procedure
1. Connect the electrical connector.

NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature corrosion.

2. Install the map lamp with the screws.

Tighten
Tighten the map lamp screws to 1 Nm (9 lb.in).

3. Install the map lamp lens.
4. Connect the negative battery cable.