Rear Head, Gasket, Valve Plate, Reed Plate, and 0-Ring
Tools RequiredJ-34993 Cylinder Alignment Rods
Disassembly Procedure
1. Recover the refrigerant.
2. Discharge the A/C system.
3. Remove the compressor.
4. Drain the oil from compressor into a suitable container. Measure and record the amount of oil drained from the compressor. Discard the used oil.
5. Remove the clutch plate and hub assembly.
6. Remove the clutch rotor and bearing.
7. Remove the clutch coil.
8. Remove the compressor through-bolts. Remove and discard the gaskets.
9. Using a wooden block and a plastic-headed hammer, tap around the edge of the rear head to disengage the head from the compressor cylinder. Separate the rear head, the head gasket, the rear valve plate, the suction reed plate and the cylinder to rear head O-ring. Discard the head gasket and the O-ring.
Assembly Procedure
1. Place the rear head on a clean, flat surface. Position the head with the control valve in the 6 o'clock position.
2. Install the cylinder alignment rods J-34993 in the mounting holes in the 11 o'clock and the 5 o'clock positions.
3. Install the head gasket over the cylinder alignment rods J-34993 with the elongated hole at the upper left pin (11 o'clock position).
4. Install the rear head valve plate over the cylinder alignment rods J-34993 with the elongated hole at the upper left alignment rod. Lower the rear head valve plate into place.
5. Install the suction reed plate over the cylinder alignment rods J-34993. Remove the alignment rod in the 5 o'clock position.
6. Lubricate the cylinder to the new rear head O-ring with clean polyalkalene glycol (PAG) refrigerant oil.
7. Install the O-ring in the cylinder O-ring groove. The O-ring seal surface of the head may be lubricated to ease assembly.
8. With the O-ring in place on the i6ar of the cylinder assembly, locate the relief boss for the compressor directly above the hole in the side of the rear head (6 o'clock position). Carefully lower the cylinder and the front head assembly over the cylinder alignment rod to the rear head.
9. Press the cylinder and the compressor housing assembly down onto the rear head using both hands.
10. Add the new through-bolt gaskets to the through- bolts and install them into the compressor assembly. Four of the through-bolts must thread into the rear head before removing the alignment rod.
Tighten
Alternately tighten the through-bolts in progressive torque sequence to 10 Nm (89 lb.in).
11. Add new PAG refrigerant oil as determined in Step 1.
12. Place the shaft nut on the shaft and rotate the compressor shaft several times.
13. Perform a leak test on the compressor. Refer to "Leak Testing (External)".
14. Install the clutch coil.
15. Install the clutch rotor and bearing.
16. Install the clutch plate and hub assembly.
17. Install the compressor.
18. Evacuate and recharge the A/C system.