Torque Converter Seal Removal
TORQUE CONVERTER SEAL REMOVALTools Required
J 41103 Torque Converter Seal Remover
1. Insert the three J 41103 puller legs under the torque converter seal (54).
2. Insert the J 41103 support body over the stator shaft (43).
3. Insert the J 41103 puller bridge over the J 41103 support body. Connect the J 41103 puller legs into the slots on the J 41103 bridge.
Important: The puller legs will damage the torque converter seal (54). Discard the torque converter seal (54) after removal.
4. Tighten the forcing screw on the J 41103 puller bridge until the J 41103 puller legs remove the torque converter seal (54).