Removal and Installation
Removal Procedure1. Raise and suitably support the vehicle.
2. Remove the rear wheels.
3. Mark the position of the wheels relative to the wheel hubs.
4. Remove the brake drum.
5. Remove the shoe and lining.
6. Clean dirt and foreign material from around the wheel cylinder brake line inlet, the pilot, and the bolt.
7. Disconnect the brake line from the wheel cylinder.
8. Plug the opening in the brake line to prevent fluid loss or contamination.
9. Remove the wheel cylinder-to-backing plate bolt.
10. Gently tap out the wheel cylinder from the backing plate, using care not to damage the bleeder valve or its cap.
Installation Procedure
1. Install the wheel cylinder to the backing plate with the wheel cylinder bolt.
Tighten the wheel cylinder-to-backing plate bolt to 8 Nm (71 inch lbs.).
2. Connect the brake line to the wheel cylinder.
Tighten the brake line to 16 Nm (12 ft. lbs.).
3. Install the shoe and lining, and the brake drum.
4. Bleed the brakes.