Front

HUB AND BEARING

- Tools Required
- 500-20 Hex Nut
- J-36661-2 Forcing Screw
- J-37105-40 Support Bridge
- J-37105-B-2 Bearing Adapter
- J-37105-B-3 Hub Adapter

Removal Procedure
1. Remove the drive axle from the front wheel hub.





2. Remove the wheel hub with the support bridge J-37105-40, the hub adapter J-37105-B-3, the hex nut 500-20, and the forcing screw J-36661-2.





3. Remove the outer snap ring.





4. Remove the wheel bearing with the support bridge J-37105-40, the bearing adapter J-37105-B-2, the hex nut 500-20, and the forcing screw J-36661-2.
5. Clean the bore of the knuckle.

Installation Procedure





1. Install the outer snap ring and push the wheel bearing into place with the support bridge J-37105-40, the bearing adapter J-37105-B-2, the hex nut 500-20, and the forcing screw J-36661-2.





2. Push the wheel hub into place with the hub adapter J-37105-B-3, the bearing adapter J-37105-B-2, the hex nut 500-20, and the forcing screw J-36661-2.
3. Install the drive axle into the front wheel hub.