Selective Washer
SELECTIVE WASHERMEASUREMENT AND INSTALLATION
- Tools Required
- J 34673 Gage Block
1. Place the J 34673 across the machined surface of the case.
2. Measure the distance between the top of the direct/ coast clutch housing (105) and the machined surface of the case (Dimension A).
3. Note the measurement of Dimension A and choose the correct selective washer. Refer to Selective Washer Table in End Play Specifications. Mechanical Specifications
Important: Position the tab on the thrust washer in the recessed area for the retainer and ball assembly (104).
4. Assemble the selective washer (104) onto the top of the input housing.
5. Assemble the thrust bearing (103) over the input shaft and onto the top of the selective thrust washer (104).