M/T - Improved Reverse Shift Feel/Part Revision

Figure 1:

89chrysler09 BODY CODE LEGEND

B1 - COLT STATION WAGON B2 - COLT 3-DOOR B3 - COLT VISTA BD - LASER


PARTS REVISION

There have been four (4) changes made in the KM200 and KM210 series transaxles. The changes were incorporated to improve the reverse shift feel. These changes entered transaxle production on December 29, 1988 beginning with transaxle No. HC6049 and later. The revised parts can be identified as follows:

1. Reverse shift lever, ribs and reinforcement have been added. Figure 1.
Models

1989 B1, B2, B3 And 1990 BD Equipped With KM200 And KM210 Transaxles


Subject

Improved Reverse Shift Feel/Part Revision


Index

TRANSMISSION


Date May 8, 1989


No.

21-14-89

(C21-18-9)

P-1839

Figure 2:

2. Bearing retainer has been reinforced. Figure 2

Figure 3:

3. Reverse Shift lever shoe has been beveled. Figure 3

Figure 4:

4. Reverse shift lever mounting bolt length increased from 18 mm to 20 mm. Figure 4
The new shift lever shoe and bolt are interchangeable with earlier built transaxle.

The new reverse shift lever and bearing retainer are interchangeable with earlier built transaxles only when replaced as a set.

CHART:

The use of the above parts is recommended when reconditioning early built transaxles. Refer to the chart below for part number information.