Shift Linkage: Adjustments

Gearshift Mechanism:

GEARSHIFT LINKAGE ADJUSTMENT (CABLE OPERATED)

Before replacing the gearshift selector cable or crossover cable for a hard-shifting complaint, disconnect both cables at the transaxle. Then, from the driver's seat, manually operate the gearshift lever through all gear ranges, If the gearshift lever moves smoothly, the cable(s) should NOT be replaced. If the gear lever binds replace the cable that is causing the binding condition.

Manual Transaxle Pinned In The Neutral Position To Adjust Gearshift:

1. Working over the left front fender, remove the lock pin from the transaxle gearshift (selector shaft) housing.
2. Reverse the lock pin (so long end is down) and insert lock pin into same threaded hole. A hole in the selector shaft will align with the lock pin, allowing the lock pin to be screwed into the housing. This operation locks the selector shaft in the 3-4 neutral position.

Remove Gearshift Knob:

Install Gearshift Knob:

3. Remove or install gearshift knob.

Remove Or Install Boot:

4. Remove or install boot or console.

Remove Cables:

Install Cables:

5. Remove or install selector and crossover cables. Cable attachment clips must be installed from the side. Install cable fittings to shifter pins by pushing with thumb.

Adjusting Crossover Cable:

CAUTION: Be sure crossover bellcrank does NOT move when tightening adjusting screw.

CAUTION: Proper torque to the crossover cable adjusting screw is very important.

6. Remove lock pin from gearshift housing and reinstall lock pin (so long end is up) in gear shift housing. Tighten lock pin to 8 N.m (70 in. lbs.).
7. Check for shift into first and reverse.
7. Gearshift mechanism and cables are now functioning properly.