Fuel Filter: Service and Repair

Fuel Filter:

REMOVAL
1. Disconnect the negative battery cable, and remove the fuel tank cap.
2. Raise, and support the vehicle for access.
3. Remove fuel filter mounting bolt.
4. Remove outlet hose from filter.
5. Remove supply hose from rear fuel tube.

INSTALLATION
1. Install the new filter assembly on the mounting plate. Check the direction of flow by the markings on the filter, and ensure it is correct.
2. Install the mounting bolt, and torque to 8 Nm (75 lb-in)
3. Install the inlet and outlet hoses, and clamps. Tighten the clamps securely. Lower the vehicle. Reconnect negative battery cable.
4. Using the appropriate tester (DRB II) or equivalent scanner, place ignition switch in "RUN" position and use Actuate Output Test "Auto Shutdown (ASD) Relay", to activate fuel pump and pressurize system.
CAUTION: The ASD relay and the fuel pump relay will remain energized for 7 minutes during this test unless the test is stopped or the ignition switch is turned to the OFF position.
5. Check for leaks.