Seat Belt Control Module: Service and Repair

Fig. 155 Seat Belt Control Module:

MODELS W/FLOOR CONSOLE

1. Remove shifter handle.
2. Unsnap shifter bezel, then disconnect electrical connectors and remove bezel.
3. Remove power mirror switch and disconnect electrical connector, if equipped.
4. Remove armrest attaching screws from center console retractor bracket.
5. Remove armrest and center console section as an assembly by unsnapping from front console section.
6. Remove center module bezel.
7. Remove sidewall attaching screws, then the module-to-bracket attaching screws.
8. Disconnect module connectors and remove module.
9. Reverse procedure to install.

MODELS W/CONSOLETTE

1. Remove trim caps and screws from console.
2. On models with manual transmissions, remove shifter knob. On models with automatic transmission, remove shifter knob and gear selector indicator.
3. On all models, remove console to retractor and lap belt assembly attaching screws.
4. Remove console.
5. Remove module-to-console attaching screws.
6. Disconnect electrical connectors and remove module.
7. Reverse procedure to install.