Power Window Regulator Replacement

Front Door Window Regulator - Power:

FRONT DOOR
1. Remove trim panel and water shield and connect window switch to wire connector.
2. Raise glass to 25 mm (1 in.) from full up position. Using suitable tape, secure door glass to upper window frame.
3. Disconnect battery negative cable.
4. Remove bolts holding window regulator to inner door panel.
5. Slide roller from window lift channel. Rotate regulator to bring lift arm through access hole first.
6. Remove regulator assembly from door.
7. Reverse the preceding operation for installation.

REAR DOOR
1. Remove trim panel and water shield.
2. Position door glass 150 mm (6 in.) up into glass opening.
3. Remove bolts holding window regulator lift bracket to door glass.
4. Remove fasteners holding power window regulator to inner door panel.
5. By hand, pull glass upward to 25 mm (1 in.) from full up position. Using suitable tape, secure door glass to upper window frame.
6. Remove regulator assembly from door.
7. Reverse the preceding operation for installation.