Manual Window Regulator Replacement

Front Door Window Regulator - Manual:

FRONT DOOR
1. Remove trim panel, silencer pad, and water shield.
2. Raise glass to 25 mm (1 in.) from full up position. Using suitable tape, secure door glass to upper window frame.
3. Remove bolts holding window regulator to inner door panel.
4. Slide roller from window lift channel. Rotate regulator to bring lift arm through access hole first.
5. Remove regulator assembly from door.
6. Reverse the preceding operation for installation.

Rear Door Window Regulator - Manual:

REAR DOOR
1. Remove trim panel, silencer pad, and water shield.
2. Position door glass 150 mm (6 in.) up into glass opening.
3. Remove bolts holding window regulator to inner door panel.
4. Slide roller from window lift channel.
5. Remove bolts holding reinforcement brace to inner door panel.
6. By hand, pull glass upward to 25 mm (1 in.) from full up position. Using suitable tape, secure door glass to upper window frame.
7. Remove regulator assembly from door.
8. Reverse the preceding operation for installation.