Transmitter Programming

PROGRAM REMOTE KEYLESS ENTRY

- Open and lower glove box door.

- Locate program line a dark green wire with a molded insulator on the end. Located behind and lower end of the glove box.

- Turn ignition switch to the ON position.

- Connect the program line from the Remote Keyless Entry Module to ground.
the door locks will lock and unlock to indicate the receiver is ready to receive transmitter code. Liftgate solenoid will not cycle.

- Press any button on the transmitter to set code. If there is a second
transmitter it has to be set at this time. The locks will cycle to confirm programming.

- Disconnect the program line from ground. This returns the system to its
normal operation mode.

- Install glove box to original position.