Seats: Service and Repair

Bench Seat:

BENCH SEAT REMOVAL
1. Move seat track to forward position.
2. Hinge seat backs forward.
3. Remove nuts holding rear of seat tracks to floor.
4. Move seat track to rearward position.
5. Remove bolts holding front of seat tracks to floor.
6. Separate seat from vehicle.

INSTALLATION
Seat adjustment latch must be engaged prior to seat installation. Verify inboard and outboard seat latch operation. Reverse the removal procedure to complete installation.

Split Bench Seat:

SPLIT BENCH SEAT REMOVAL
1. Move seat track to forward position.
2. Hinge seat back forward.
3. Disengage power seat wire connector from body harness, if equipped.
4. Remove nuts holding outboard and inboard tracks to floor.
5. Move seat track to forward position.
6. Remove bolt holding inboard seat track to bottom of center occupant seat.
7. Remove bolts holding front of seat tracks to floor.
8. Lift center occupant seat upward to clear rear attachment stud.
9. Separate seat from vehicle.

INSTALLATION
1. Position seat in vehicle.
2. Install bolts holding front of seat tracks to floor. Tighten the bolts with 28 Nm (250 in-lbs) torque.
3. Install bolt holding inboard seat track to bottom of center occupant seat. Tighten the bolt with 28 Nm (250 in-lbs) torque.
4. Install nuts holding outboard and inboard tracks to floor. Tighten the nuts with 40 Nm (30 ft. lbs.) torque.
5. Connect power seat wire connector to body harness, if equipped.

CENTER SEAT/CONSOLE REMOVAL
1. Remove bolts on driver and passenger seat inboard seat tracks.
2. Separate center section.

INSTALLATION
1. Position and align center section on driver and passenger seat inboard seat tracks.
2. Install bolts. Tighten to 19.5 Nm (14 ft. lbs.) torque.

REAR SEAT REMOVAL-CLUB CAB
1. Move front seat track to full forward position.

Rear Seat Release Handle:

Rear Seat Stowed:

2. Turn release handle on underside of rear seat to disengage seat cushion and move seat to the stowed position.

Rear Seat Removal/Installation:

3. Remove side support bracket screws and lift seat to disengage from cab.

INSTALLATION
1. Position seat in vehicle.
2. Align seatback hooks with loops on cab rear panel.
3. Align side support alignment tabs, and lower seat into place.
4. Install side support bracket screws. Tighten the screws to 28 Nm (250 in-lbs) torque.
5. Turn release handle to disengage seat from stowed position and push seat cushion downward to lock into place.