Blower Motor Relay: Service and Repair

Fig 39 Blower Motor Relay Removal/Installation:

NOTE: The blower motor relay and wire harness connector are snap-fit onto a blade-type retainer located on the stop lamp switch mounting bracket. The stop lamp switch mounting bracket is secured with two screws to the inboard side of the brake pedal support bracket, under the driver side of the instrument panel. To remove the relay:

1. Disconnect and isolate the battery negative cable.
2. Reach under the knee blocker on the driver side of the instrument panel between the throttle and brake pedals, and unsnap the relay from the blade on the stop lamp switch bracket.
3. Lower the relay from under the instrument panel far enough to unplug the relay from the wire harness connector.
4. To install the relay, align the terminals with the cavities in the relay wire harness connector and push the relay firmly into place.
5. Reverse the remaining removal procedures to complete the installation.
6. Test the relay operation.