Quick Connect Installation Procedure

1. Wipe the tube end which will be inserted into the quick connect with a clean rag.

2. Check the tube surfaces for burrs. Remove burrs as necessary.

3. Apply a coating of clean transmission fluid over the entire tube end surface up to the bead.

4. Push the tube into the quick connect until the retainers seat and a click is heard. Pull back on the tube and quick connect to ensure that the quick connect is locked in place. Do not rely only on the audible click to confirm that a secure connection has been made.

Caution:
It is extremely important that cooler tube and quick connect seating be checked as described in step 4. If the tube and quick connect are not fully secured, normal fluid pressure could eventually unseat the joint resulting in fluid loss, transmission damage and/or fire.