Interior Moulding / Trim

Cowl And Door Sill Cover:

COWL AND DOOR SILL COVER REMOVAL
1. Remove screw holding cowl trim to cowl.
2. Remove screws holding door sill cover to floor at door sill.
3. Separate door sill and cowl trim from vehicle.
4. Reverse the preceding operation for installation.

A-Pillar Grab Handle:

A-PILLAR GRAB HANDLE REMOVAL
1. Using a small flat blade screw driver, Pry trim plugs from A-pillar grab handle.
2. Remove screws holding grab handle to A-pillar.
3. Separate A-pillar grab handle from vehicle.
4. Reverse the preceding operation for installation.

A-Pillar Moulding:

A-PILLAR MOLDING REMOVAL

NOTE: Damage to trim molding may occur during removal. verify availability of replacement molding before removing.

1. Remove A-pillar grab handle, if equipped.
2. Disengage clips holding A-pillar molding to A-pillar.
3. Separate A-pillar molding from vehicle.
4. Reverse the preceding operation for installation.

Quarter Trim Panel:

QUARTER TRIM PANEL REMOVAL - REGULAR CAB
1. Remove rear floor stowage tray.
2. Remove door sill cover as necessary to clear quarter trim.
3. Remove bolt holding seat belt anchor to floor.
4. Remove push-in fasteners holding quarter trim panel to lower quarter panel.
5. Disengage clips holding quarter trim panel to upper quarter panel.
6. Separate quarter trim panel from quarter panel.
7. Pull seat belt webbing through opening in quarter trim panel.
8. Reverse the preceding operation for installation.

QUARTER TRIM PANEL REMOVAL - CLUB CAB
1. Remove rear seat.
2. Remove door sill cover as necessary to clear quarter trim.

Cup Holder Removal:

3. Using a trim stick or small flat blade screwdriver, remove cup holder.
4. Remove lower seat belt anchor bolts.

Quarter Trim Panel - Club Cab:

5. Remove screws holding club cab quarter trim panel to quarter panel.
6. Separate club cab quarter trim panel from quarter panel.
7. Pull seat belt webbing through opening in quarter trim panel and remove panel from vehicle.

INSTALLATION
1. Position trim panel in vehicle and pull seat belt webbing through opening in quarter trim panel.
2. Position trim panel at quarter panel and install trim panel screws.
3. Install lower seat belt anchor bolts.
4. Install cup holder.
5. Install door sill cover as necessary.
6. Install rear seat.

REAR CLOSURE PANEL TRIM REMOVAL
1. Remove quarter trim panels.
2. Remove rear floor stowage tray.
3. Remove stowage bins.
4. Remove stowage net.

Rear Closure Panel Trim:

5. Remove screws holding bottom of rear closure panel trim to floor.
6. Remove screws holding rear closure panel trim to rear cab wall.
7. Disengage clips holding top of rear closure panel trim to rear cab wall.
8. Remove push-in fastener in top center of rear closure trim panel.
9. Separate rear closure panel trim from vehicle.
10 Reverse the preceding operation for installation.

Overhead Assist Handle:

OVERHEAD ASSIST HANDLE REMOVAL
1. Disengage tabs holding assist handle end covers to assist handle.
2. Remove screws holding overhead assist handle to roof rail.
3. Separate overhead assist handle from vehicle.
4. Reverse the preceding operation for installation.

Coat Hook Removal:

Coat Hook:

COAT HOOK REMOVAL
1. Pry retainer plug from center of coat hook.
2. Pull coat hook out of rear header panel.
3. Reverse the preceding operation for installation.