Transfer Shaft

Rear Cover Bolts:

Remove Rear Cover:

Remove Transfer Shaft Gear Retaining Nut:

Transfer Shaft Gear Nut And Washer:

Remove Transfer Shaft Gear:

Transfer Shaft Gear And Shim:

Remove Transfer Shaft Gear Bearing Cone:

NOTE: Use special tool L-4406-1 with adapter L-4406-3.

Install Transfer Shaft Gear Bearing Cone:

Governor Support Bearing:

Remove Governor Support Retainer Bearing Cup:

Install Governor Support Retainer Bearing Cup:

Low-Reverse Band Anchor Pin:

Governor Assembly:

NOTE: Remove both governor valves and governor body.

Transfer Shaft Bearing Snap Ring:

Transfer Shaft And Bearing Retainer Assembly:

Transfer Shaft And Bearing Retainer Assembly:

Transfer Shaft And Bearing Retainer:

Transfer Shaft Bearing Cone:

Install Transfer Shaft Bearing Cone:

Remove Transfer Shaft Bearing Cup:

Install Transfer Shaft Bearing Cup:

DETERMINING SHIM THICKNESS
Shim thickness need only be determined if any of the following parts are replaced:
- Transaxle case
- Transfer shaft
- Transfer shaft gear
- Transfer shaft bearings
- Governor support retainer
- Transfer shaft bearing retainer
- Retainer snap ring
- Governor support
Refer to Bearing Adjustment Procedure, to determine proper shim thickness for correct end play.

Transfer Shaft Gear Retaining Nut:

Tighten transfer shaft gear retaining nut to 271 Nm (200 ft. lbs.)

Transfer Shaft End Play: