Assembly

Install Both Output Bearing Cups:

Install Piston Retainer Gasket:

Install Piston Retainer:

Install Retainer Attaching Screws:

Install Low/Reverse Clutch Piston:

To assemble the transaxle centerline, refer to the following procedures (Output Gear Bearing Adjustment, Transfer Shaft Bearing and Determining No. 4 Thrust plate Thickness - Input Shaft End Play).

Guide Bracket Disassembled:

Guide Bracket:

Pivot Shaft And Guide Bracket:

Install Guide Bracket Pivot Shaft:

Install Anchor Shaft And Plug:

CAUTION: When installing, be sure guide bracket and split sleeve touch the rear of the transaxle case.

Install Low/Reverse Piston Return Spring:

Low/Reverse Spring Compressor Tool:

Compressor Tool In Use:

Install Snap Ring:

Install Rear Carrier Bearing Cone:

Install Rear Carrier Assembly:

Install Output Gear Bearing Cone: