Front Door Panel: Service and Repair

REMOVAL
1. Using a trim stick (C-4755), pry courtesy lamp from door trim.
2. Disengage wire connector from courtesy lamp.
3. If equipped. remove screws holding door assist handle to inner door panel.
4. If equipped, remove screw holding door pull cup to inner door panel.
5. If equipped, remove screws holding trim panel to door from below map pocket.
6. If equipped, remove window crank.
7. Using a trim stick. remove screw cover from switch panel.
8. Remove screws holding switch panel to door trim.

Front Door Switch Panel:

9. Separate power accessary switch from door trim.
10. Disengage power switch from wire connector.

Memory Seat/Mirror Switch:

11. If equipped, using a small flat blade screw driver, remove memory seat/mirror switch and disengage wire connector.
12. If equipped. remove the holding door trim to door panel from behind inside latch release handle.

Front Door Trim Panel:

13. Disengage clips holding door trim to door frame around perimeter of panel.
14. Lift trim panel upward to disengage flange from inner belt molding at top of door
15. Tilt top of trim panel away from door to gain access to latch linkage.

Inside Door Handle Linkage:

16. Disengage clip holding linkage rod to inside latch release handle.
17. Separate linkage rod from latch handle.
18. Separate front door trim panel from vehicle.

INSTALLATION
1. Hold top of trim panel away from door to gain access to latch linkage.
2. Place linkage rod in position on latch handle.

Inside Door Handle Linkage:

3. Engage clip to hold linkage rod to inside latch lease handle.
4. Place front door trim panel in position on door.
5. Engage trim panel into inner belt molding at top of door.

Front Door Trim Panel:

6. Engage clips to hold door trim to door frame around perimeter of panel.
7. If equipped, install screw to hold door trim to or panel behind inside latch release handle.

Front Door Switch Panel:

8. If equipped, engage power switch into wire connector.
9. Place power accessory switch in position on or trim.

Memory Seat/Mirror Switch:

10. Engage wire connector into memory seat/mirror switch and install switch into trim panel.
11. install screws to hold accessory switch panel door trim.
12. Install screw cover into switch panel.
13. If equipped, Install window crank.
14. If equipped, install screws to hold trim panel door inside map pocket.
15. If equipped, install screw to hold door pull cup inner door panel.
16. If equipped install screws to hold door assist handle to inner door panel.
17. Engage wire connector into courtesy lamp.
18. Install lamp in door trim.