Rear Wiper LED Flashing Once, Int. LED Flashing Six Times

THE EVAPORATOR PROBE IS SHORTED.
1. Using a voltmeter, check Pin 1 of the evaporator probe wiring connector for 0.1 - 4.75 volts, If OK, go to Step 2. If less than 0.1 volts, check for loose or corroded connector, open or shorted circuit and repair as necessary.
2. Using a ohmmeter, check Pin 2 for a good ground, If OK, go to Step 3. If not OK, check for shorted circuit and repair as necessary.
3. If ground and power circuit are OK, replace Evaporator Probe
4. Once repairs are completed, press the intermittent button about 5 seconds until all LED's light to remove fault code from memory. Then repeat the Calibration Diagnostic and Cool-down test. Repeating the test is necessary to clear the fault codes.