Power Steering Pump Removal and Installation

1. Disconnect battery ground cable, then remove serpentine drive belt.
2. Raise and support vehicle, then place drain pan under vehicle.
3. Disconnect low pressure hose and high pressure line from pump, then remove hose from pump to remote reservoir.
4. Remove right wheel, then the bolts holding pump to generator/power steering/belt tensioner mounting bracket.
5. Remove nut and bolt holding engine block to pump support strut. Remove strut from engine and pump. Lay pump assembly down on top of steering gear.
6. Remove serpentine drive belt tensioner from bracket, then generator/pump bracket and support strut.
7. Lower vehicle, then remove power steering reservoir from vehicle.
8. Remove engine wiring harness routing clip from generator bracket.
9. Loosen bolt holding engine bracket assembly to engine support assembly.
10. Remove upper generator to generator bracket mounting bolt, then rotate generator assembly back toward dash panel.
11. Remove generator bracket from engine and intake manifold.
12. Remove lower generator mounting bolt. With wiring harness connected, remove generator and place on intake manifold.
13. Remove power steering pump out through top, in area between engine and dash panel where generator was mounted.
14. Reverse procedure to install.