Installation Procedure

1. With oil pan removed from transmission case for routine service or transmission repair proceed to step # 2.

2. Clean any residue from oil pan and magnet.

3. Replace O-ring and filter on bottom of valve body.

4. Using a plastic or wooden scraper, remove old RTV from transmission case rails.

CAUTION:
ALUMINUM COMPONENTS ARE VERY SUSCEPTABLE TO METAL TRANSFER WHEN OLD GASKET MATERIAL IS REMOVED FROM THEM. USE EXTREME CARE WHEN CLEANING THESE COMPONENTS.

5. Apply thin coat of transmission fluid to oil pan and transmission case pan rails.

6. Orient reusable gasket properly with bolt holes and assemble oil pan and gasket to transmission case. Tighten oil pan bolts to 19 Nm (165 in lbs.).

7. Refill transmission to the proper level with MOPAR ATF + 3 Type 7176, p/n 05010124AA, or MOPAR ATF +4 Type 9602, p/n 05013457AA, for 1999 JA/LH/PR vehicles.

CAUTION:
DO NOT OVERFILL TRANSAXLE. DO NOT ADD OIL IF LEVEL IS BETWEEN: LOWER HOLES FOR WARM OIL (100°F). UPPER HOLES FOR HOT OIL (180°F.).