Manifold Pressure/Vacuum Sensor: Service and Repair

Throttle Body Connector Locations:

NOTE:
The MAP sensor is located on the front of the throttle body. An L shaped rubber fitting is used to connect the MAP sensor to throttle body.


REMOVAL

NOTE: The throttle body must be removed from the intake manifold for MAP sensor removal,

1. Remove air cleaner assembly.
2. Remove throttle body.
3. Remove two MAP sensor mounting screws.
4. While removing MAP sensor, slide the rubber vacuum fitting from the throttle body.
5. Remove rubber fitting from MAP sensor.


INSTALLATION
1. Install rubber fitting to MAP sensor.
2. Position sensor to throttle body while guiding rubber fitting over throttle body vacuum nipple.
3. Install MAP sensor mounting screws. Tighten screws to 3 Nm (25 in. lbs.) torque.
4. Install throttle body.
5. Install air cleaner.