Overhaul

Detent Spring Attaching Screw And Spring:

Using Tool L-4553 On Valve Body Screw:

Remove Or Install Valve Body Screws:

Transfer Plate And Separator Plate:

Steel Ball Locations:

Remove Or Install Throttle Shaft E-Clip:

Throttle Shaft E-Clip, Washer, And Seal:

Manual Valve Lever Assembly:

Throttle Valve Lever Assembly:

Manual Valve:

Pressure Regulator And Adjusting Screw Bracket:

Pressure Regulators And Manual Controls:

Governor Controls:

Pressure Regulator Valve Plugs:

Shift Valves And Shuttle Valve:

NOTE: Tighten all valve body screws to 5 Nm (40 inch lbs.).

Do not clamp any portion of valve body or transfer plate in a vise. Any slight distortion of the aluminum body or transfer plate will result in sticking valves, excessive leakage, or both. When removing or installing valves or plugs, slide them in or out carefully. Do not use force.

NOTE: Tag all springs as they are removed for reassembly identification.