Installation

1. Position engine and transmission assembly under vehicle and slowly lower the vehicle over the engine and transmission. It may be necessary to move the engine/transmission assembly with the cradle for clearance around body flanges.
2. Align engine and transmission mounts to attaching points. Install mounting bolts at the right engine and left transmission mounts.
3. Slowly raise vehicle enough to remove the engine dolly and cradle Special Tools 6135, 6710, 6848 and 6909, or equivalents.
4. Remove Special tools 6912. or equivalent and install bending braces.
5. Lower vehicle. Install generator and wiring harness.
6. Connect wiring harness on the front of the engine.
7. Install Air Conditioning Compressor.
8. Install power steering pump and bracket and accessory drive belt.
9. Raise vehicle and install axle shafts.
10. Install transmission and engine mount and bracket assemblies.
11. Connect exhaust system to manifold.
12. Install left and right inner splash shields.
13. Connect automatic transmission shifter linkage.
14. Lower vehicle and connect fuel line and heater hoses. Remove plugs from rear heater hoses and install, if equipped.
15. Install ground straps. Connect engine and throttle body connections and harnesses.
16. Connect throttle body linkage.
17. Install radiator and fan module assembly. Install radiator hoses. Fill cooling system.
18. Install battery tray, battery and cover.
19. Install air cleaner and hoses.
20. Install oil filter. Fill engine crankcase with proper oil to correct level.
21. Start engine and run until operating temperature is reached.
22. Adjust transmission linkage, if necessary