Instrument Panel Left Louver Housing

Instrument Cluster Bezel:

REMOVAL
1. Remove the instrument cluster bezel. Refer to Instrument Cluster Bezel Removal and Installation procedures.
2. Place cluster bezel on a clean surface face down with the head lamp switch to the right side.
3. Using a flat bladed tool, release the louver housing locks tabs.
4. Release the upper left lock tab first, then the other upper lock tab.
5. Applying pressure on the housing, release the lower lock tabs.
6. Push out the louver housing from the cluster bezel.

INSTALLATION
1. Verify the function of the vanes.
2. Set louver housing into the cluster bezel and align the slot of the housing with the T location pins.
3. Using care do not push on the vanes, apply pressure on outer edge of the housing and push louver housing into place.
4. After in place check function of the vanes.