42/44RE (A500) 4-Speed

FRONT BAND ADJUSTMENT
The front (kickdown) band adjusting screw is located on the left side of the transmission case above the manual valve and throttle valve levers.
1. Raise vehicle.

Frontband Adjustment Screw Location:

2. Loosen band adjusting screw locknut. Then back locknut off 3 - 5 turns. Be sure adjusting screw turns freely in case. Apply lubricant to screw threads if necessary.
3. Tighten band adjusting screw to 8 Nm (72 inch lbs.) torque with Inch Pound Torque Wrench C-3380-A, a 3 inch extension and 5/16 socket.

Band Adjustment Adapter Tool:

CAUTION: If Adapter C-3705 is needed to reach the adjusting screw, tighten the screw to only 5 Nm (47 - 50 inch lbs.) torque.

42RE TRANSMISSION
- Back off front band adjusting screw 3-5/8 turns.
- Hold adjuster screw in position and tighten locknut to 41 Nm (30 ft. lbs.) torque.

44RE TRANSMISSION
- Back off front band adjusting screw 2-1/4 turns.
- Hold adjuster screw in position and tighten locknut to 41 Nm (30 ft. lbs.) torque.

4. Lower vehicle.

REAR BAND ADJUSTMENT
The transmission oil pan must be removed for access to the rear band adjusting screw.
1. Raise vehicle.
2. Remove transmission oil pan and drain fluid.

Rear Band Adjusting Screw Location:

3. Loosen band adjusting screw locknut 5-6 turns. Be sure adjusting screw turns freely in lever.
4. Tighten adjusting screw to 8 Nm (72 inch lbs.) torque.

42/44RE TRANSMISSION
- Back off adjusting screw 4 turns.
- Hold adjusting screw in place and tighten locknut to 34 Nm (25 ft. lbs.) torque.

5. Position new gasket on oil pan and install pan on transmission. Tighten pan bolts to 17 Nm (13 ft. lbs.) torque.
6. Lower vehicle and refill transmission with MOPAR ATF+4, Type 9602 fluid.