Front Servo Piston

DISASSEMBLY

Front Servo:

1. Remove seal ring from rod guide.
2. Remove small snap ring from servo piston rod. Then remove piston rod, spring and washer from piston.
3. Remove and discard servo component O-ring and seal rings.

ASSEMBLY
Clean and inspect front servo components.
1. Lubricate new O-ring and seal rings with petroleum jelly and install them on piston, guide and rod.
2. Install rod in piston. Install spring and washer on rod. Compress spring and install snap ring.
3. Set servo components aside for installation during transmission reassembly.