Power Seat Switch: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the screw that secures the recliner lever to the recliner mechanism release shaft on the outboard side of the driver side front seat.
3. Pull the recliner lever off of the recliner mechanism release shaft.
4. Remove the three screws that secure the driver side seat cushion side shield to the outboard seat cushion frame.
5. Pull the driver side seat cushion side shield away from the seat cushion frame far enough to access the power seat switch module wire harness connector.
6. Unplug the wire harness connector from the power seat switch module.
7. Remove the seat cushion side shield and power seat switch module from the seat as a unit.

Power Seat Switch Remove/Install - Typical:

8. Remove the two screws that secure the power seat switch to the inside of the seat cushion side shield.
9. Remove the power seat switch from the seat cushion side shield.
10. Reverse the removal procedures to install. Tighten the switch mounting screws to 2.2 N.m (20 in. lbs.).